Filter
Top Products
9
3. Use the NUMBER PAD to enter any number between 1 and 16,
but not the one you wrote in step 1.
4. Press POUND (#). If you entered the address correctly, SAT will
flash three times.
Write down the number you entered in Your Remote Control
Codes on page 24.
5. Press RECORD. Make sure the Remote Address you see on
the System Information screen is the same as the one you
entered in step 3. If it isn't, the remote cannot control the receiver.
6. Press SELECT to close the System Information screen.
CHANGING THE UHF FREQUENCY USING THE A/B
S
WITCH (DISH PLAYER-DVR 942 ONLY)
Your remote has a switch to change the UHF frequency that your
remote control uses. It comes preset to the A position but you can
change the setting to the B position to lessen the likelihood of any other
UHF remote interfering with yours. This feature is available only with
the DISH Player-DVR 942.
1. Remove the battery cover from the remote control.
2. Use a small screw driver or a paper clip to carefully
change the setting.
3. Put the battery cover back on the remote control.
4. Use the SYS INFO button on the front panel to
open the System Information screen.
5. Press RECORD on the remote control.
6. Make sure the System Information screen
shows the correct band information:
• Switch position A - IR/UHF Pro Band A
• Switch Position B - IR/UHF Pro Band B
All receiver models except the DISH Player-DVR
942 must use switch position A or else your remote
control will not work.
Battery
A
B
62book.book Page 9 Tuesday, April 4, 2006 1:45 PM