D-Link DGS-1210-16 TV Receiver User Manual


 
Configuration D-Link Web Smart Switch User Manual
7
7
3
3
Figure 4.86Add Access Profile
The steps of adding an access profile are described below:
1) After selecting the Select Profile ID and Select Frame Type (MAC ACL or IPv4 ACL), specify attributes
like Untagged/Tagged (for MAC), or ICMP/IGMP/TCP/UDP/Protocol ID (for IPv4). Click Select and a
simplified frame diagram will be displayed.
Figure 4.87ACL > Access Profile List > Add ACL Profile
The Add ACL Profile window contains the following fields:
Select Profile ID: Select an unique identifier number for this profile set. This value is from 1 to 50.
Select Frame Type: Select frame type based on MAC address, or IPv4 address. This will change the
window according to the requirements for the type of profile.
MAC ACL Select to instruct the Switch to examine the layer 2 part of each packet header.
Tagged: Defines the profile Layer 2 to match 802.1Q fields in the Layer 2 header.
Untagged: Defines the profile Layer 2 to check the Layer 2 header without the 802.1Q fields.
IPv4 ACL Select to instruct the Switch to examine the IPv4 address in each frame’s header.
ICMP: Specifies ICMP as the Layer 3 protocol that the access profile checks.
IGMP: Specifies IGMP as the Layer 3 protocol that the access profile checks.