Filter
Top Products
-6-
V. BEFORE OPERATION
SECURITY
Before operation, check if the voltage of the unit is in line with the local voltage.
Hold the plug to disconnect it from the mains outlet. Do not pull the power cord.
When the plug of the unit is connected to the mains outlet, the unit will be still connected to AC even of the power is
turned off.
Disconnect the plug as soon as liquid or objects enter the unit. The unit cannot be used until being checked by
experts.
Do not open the cabinet. Laser rays employed by the unit may damage eyes. Any servicing should be done by
qualified service personnel.
PLACEMENT
Put the unit where ventilation is good enough to prevent overheating.
Never put the unit in direct sunlight or near heat sources.
Place the unit horizontally, never put any heavy object on the unit.
To protect the pickup, do not put the unit where there is much dust. If there is dust on the pickup, use a cleaning disc
to clean it.
Refer to the operation instructions of the cleaning disc you bought.
CONDENSATION
Moisture will appear on the pickup lens in the following cases:
The unit is suddenly moved from a cold place to a warm place.
The unit is put in a room with a heater, or in cold air from an air - conditioner.
Use the unit in a humid place. In these cases, the unit cannot work. Unload the disc and leave the unit on for about
one hour to evaporate the water.
VI. PRECAUTIONS FOR DISCS
HANDLING DISC
To keep the disc clean, do not touch the play sides of the disc.
Do not attach paper or tape to the disc.
Keep the disc away from direct sunlight or heat sources.
Store the disc in a disc case after playback.
CLEANING DISC
Before playback, wipe the disc outwards from the centre with clean cloth.
Do not use any type of solvent such as thinner, benzine, commercially
available cleaners or antistatic spray.
Figure 4
Figure 5