Filter
Top Products
.Enter'5'to③ chan ge the curre n t disk dr ive and press 'ENTER'.
. Select the drive you want to install and format, in this example disk '2' but note that this④
may vary from your setup!
⌕ If you can not see the external hard drive at this point, please check your jumper settings,
cable connection, power supply and if required, the driver installation.
For 2 .5" H ard Drive, you can also connect the drive directly to your internal IDE⌕ bu s if you
encounter problems with the external drive and install it later formatting.
. Choose '1' to⑤ c reate a primary DOS partition and follow the on screen instructions. After you
have created the partition according to your requirement, close the MS-DOS command
prompt by typing 'exit' and press 'ENTER'.