Dynex DX-22L150A11 Flat Panel Television User Manual


 
10
Making connectionsDX-15L150A11/DX19L150A11/DX-22L150A11
3 Connect the other end of the component video cable to the
COMPONENT Y/Pb/Pr jacks on the back of your TV.
4 Connect an audio cable to the AUDIO OUT jacks (L/R) on the
component device.
5 Connect the other end of the audio cable to the
COMPONENT AUDIO-R and AUDIO-L jacks on the back of
your TV.
To play from the component video device:
1 Turn on the TV, then press INPUT. The INPUT SOURCE menu
opens.
2 Press or to select Component, then press ENTER.
Note: You can also press COMP to select Component.
3 Turn on the component video device and start playback. Refer to
the instructions that came with the component video device.
Connecting an antenna, cable TV, or
satellite TV box via coax
If you are connecting a satellite TV or cable box, you can use one
of the following (if available):
Best - HDMI cable
Better - Video component cables
Better - S-Video cable
Good - Video composite cable
Acceptable - 75-ohm coaxial cable.
To connect an antenna, cable TV, or satellite TV box:
Connect one end of a 75-Ohm, coaxial cable to the RF jack on the
back of the TV, then connect the other end of the cable to the
antenna or cable TV wall jack.
Notes:
We recommend using a 75-Ohm, coaxial cable to reduce interference
and noise that may be caused by radio wave transmissions.
Do not bundle the coaxial cable with the power cord or any other
cables.
If you are using an antenna and reception is not good, contact a
service technician to adjust the antenna.
Connecting a VCR
Note: If the VCR has an HDMI jack (best), component jacks (better), or an
S-Video jack (good), connect the VCR using the best available
connection.
To connect a VCR:
1 Make sure that your TV’s power cord is unplugged and the VCR is
turned off.
2 Connect one end of a standard AV cable (not included) into the
AV IN 1 VIDEO jack on the back of the TV, then connect the other
end of the cable to the AV OUT VIDEO jack on the VCR.
-OR-
For a better picture, you can connect an S-Video cable to the
S-VIDEO OUT jack on the VCR and the S-VIDEO jack on your TV.
3 Connect the audio connectors of the AV cable (the red and white
connectors) to the AV OUT AUDIO jacks of the VCR, then connect
them to the AV IN 1 AUDIO-L and AUDIO-R jacks on the back of
your TV.
To play the VCR:
1 Turn on the TV, then press INPUT. The INPUT SOURCE menu
opens.
2 Press or to select AV1 or S-Video, then press ENTER.
Note: You can also press VIDEO once to select AV1 or three times for
S-Video.
3 Turn on the VCR, insert a videotape, then press PLAY on the VCR.
75-Ohm coaxial cable
To wall jack
Back of TV
OUT
IN
ANTENNA
75-Ohm coaxial cable
Cable box or satellite receiver
Back of TV
HDMI
Video or S-Video
Component
ANT/CABLE INANT
/C
ABLE I
N
ANT/CABLE INANT/CABLE I
N
VCR
Audio cable
Back of TV
Note: Cables are often color-coded to connectors.
Connect yellow to yellow, red to red, and white to white.
S-Video cable
Back of TV
VCR
Video cable
Audio cable
DX-15L-150A11_09-1036.book Page 10 Tuesday, December 1, 2009 9:52 AM