Dynex DX-22L150A11 Flat Panel Television User Manual


 
18
Changing channel settingsDX-15L150A11/DX19L150A11/DX-22L150A11
Changing channel settings
Automatically scanning for channels
When you scan for channels, your TV searches for channels with signals
and stores the channel information in the channel list. When you press
CH or CH , your TV goes to the next or previous channel in the
channel list and skips the channels that do not have signals.
If the TV signal source changes, for example if you change from an
outdoor antenna to cable TV (no box), you need to scan for channels.
To auto scan for channels:
1 Press MENU. The on-screen menu opens.
2 Press or to highlight CHANNELS. The CHANNELS menu
opens.
3 Press or to highlight Auto Channel Search, then press
ENTER. The Auto Channel Search screen opens.
4 Press or to select Antenna or Cable, then press ENTER to
start the scan.
You can see the progress of the search and the number of
channels found in the on-screen menu. After the scan is
complete, the menu closes and your TV tunes to the first channel
on the list.
Notes:
You can press EXIT to stop the search at any time.
If you don’t need analog channels after auto searching for digital
channels, you can press EXIT or MENU within ten seconds of the
prompt.
You don't need to scan for channels if you are using a cable or satellite box
because the available channels are provided by the box. Press EXIT to
close the menu.
5 Press MENU to return to the previous menu, or press EXIT to
close the menu.
Hiding and adding channels
You can delete channels from the channel list so that your TV skips the
channels when you press CH /CH . You can still tune to the hidden
channel by using the number buttons. You can also add channels to the
list.
To hide or add a channel:
1 Press MENU. The on-screen menu opens.
2 Press or to highlight CHANNELS. The CHANNELS menu
opens.
3 Press or to highlight Add/Skip Channels, then press
ENTER or . The Channel List screen opens.
4 Press , , or to highlight the channel you want to hide or
add (the default is to show the channel), then press ENTER to
remove the check mark from the channel. You can also add a
channel by selecting it, then pressing ENTER to place a check
mark next to it.
DX-15L-150A11_09-1036.book Page 18 Tuesday, December 1, 2009 9:52 AM