Filter
Top Products
Troubleshooting
31
DX-46L260A12
Remote control
Good picture, but no
sound.
• Increase the volume.
• Make sure that the sound is not muted.
• Unplug the headphones.
• Make sure that the correct audio mode is
selected.
• Make sure that the audio cables are
connected correctly and securely to the
back of your TV.
• Make sure that the antenna or cable TV is
connected correctly and securely. See
“Connecting a cable or satellite box” on
page 8 or “Connecting an antenna or cable
TV (no box)” on page 10.
• If you are using an antenna, the digital
channel signal may be low.
• The audio cable(s) you are using may be
bad. Try a new set.
Poor picture • Make sure that the room is not too bright.
Light reflecting off the screen can make the
picture difficult to see.
• If an S-VHS camera or a camcorder is
connected while another connected device
is turned on, the picture may be poor. Turn
off one or more devices.
Good sound but
poor color
• Adjust the contrast, color, and brightness
settings.
Audio noise • Other devices (for example, surround sound
receiver, external speakers, fans, or hair
dryers) may be interfering with your TV. Try
turning off one device at a time to
determine which device is causing
interference. Once you have determined
which device is causing interference, move
it further from the TV to eliminate the
interference.
No output from one
of the speakers
• Adjust the audio balance. See “Adjusting
sound settings” on page 19.
• Make sure that the audio cables are
connected correctly and securely to the
back of your TV.
After images appear • Do not display a still image, such as a logo,
game, or computer image, for an extended
period of time. This can cause a permanent
after-image to be burned into the screen.
This type of damage is not covered by your
warranty.
Problem Solution
Problem Solution
Remote control
does not work.
• Make sure that the power cord is correctly
connected to your TV and a power outlet.
• Make sure that there are no obstructions
between the remote control and the remote
control sensor on the front of the TV.
• Point the remote control directly at the
remote control sensor on your TV. For the
location of the remote control sensor, see
“Front” on page 5.
• Make sure that the batteries are installed
correctly. See “Installing remote control
batteries” on page 15.
• Replace dead batteries with new batteries.
See “Installing remote control batteries” on
page 15.
Trouble
programming your
existing universal
remote control.
• See instructions and a table of common
codes in “Programming a different universal
remote control” on page 34.
• Codes are subject to change. For up to date
codes, go to www.Dynexproducts.com.
• Replace dead batteries with new batteries.
See “Installing remote control batteries” on
page 15.
• Refer to the User Guide that accompanied
your universal remote control and contact
the manufacturer if problems persist.
DX-46L260A12_11-0091_MAN.book Page 31 Monday, April 18, 2011 1:48 PM