Filter
Top Products
Maintenance
17
DX-55L150A11
General
Note: If the problem is not solved by using these troubleshooting
instructions, try turning off your TV, then turning it on again.
Maintenance
Just like with any other household appliance, the performance and
life-expectancy of your TV depends on how well you maintain it. Follow
the procedures described here to clean the TV case and the LCD screen.
Cautions:
• Make sure that the TV is turned off and the power cord is
disconnected from the power outlet before cleaning the TV.
• Never spray or pour any liquid directly onto the screen or the case.
Cleaning
• Clean your TV with a soft, dry cloth. If surfaces are extremely
dirty, use a soft cloth dampened with a small amount of
non-ammonia, non-alcohol-based, non-abrasive detergent
solution.
• Clean the screen with a clean, soft, lint-free cloth. If additional
cleaning is necessary, apply a small amount of non-ammonia,
non-alcohol-based, non-abrasive detergent solution to the cloth.
Specifications
Specifications subject to change without notice.
Weight and dimensions shown are approximate.
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this
product is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply within the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced technician for help.
FCC warning
Changes or modifications not expressly approved by the party
responsible for compliance with the FCC Rules could void the user’s
authority to operate this equipment.
Problem Solution
One or more channels do
not display.
• Make sure that the channels are
not blocked. For more
information, see “Setting parental
controls” on page 14.
Password is lost. • Enter 9999 to access parental
controls, then set a new
password. For more information,
see “Setting parental controls” on
page 14.
Some settings cannot be
accessed.
• If a setting is grayed, the setting is
not available in the current video
input mode.
TV cabinet creaks. • When the TV is in use, the
temperature rises naturally and
may cause the cabinet to expand
or contract which can cause a
creaking noise. This is not a
malfunction.
Control buttons on the TV
do not work.
• Disconnect the power cord, wait a
few seconds, then reconnect the
power cord and turn on the TV.
TV type
LCD
TV panel
55-inch FHD LCD
TV system
NTSC-M, ATSC
Receiving channels
VHF: 2 - 13
UHF: 14 - 69
CATV: 1 - 125
CADTV: 1-135
DTV: 2-69
Audio multiples
BTSC system
Audio out
10 W x 2
Power requirement
AC 120 V, 60 Hz
Power consumption
285 W
Dimensions
(W×H×D with stand)
51.97 × 34.65 × 16.14 inches
(1320 × 880 × 410 mm)
Weight
100.33 lbs. (45.5 kg)
Input terminals
Composite video/L and R audio (2)
Component video/L and R audio (2)
HDMI (4)
VGA and PC/DVI audio (1)
ANT/Cable (1)
Output terminals
Digital Coaxial Audio (1)
Headphone (1)
L/R Audio (1)
Control terminals
SERVICE PORT (1)
DX-55L150A11_10-1135_MAN_ENG_V1.book Page 17 Monday, October 25, 2010 12:02 PM