Filter
Top Products
Using your T
V
17
Using your TV
Note: Unless otherwise stated, all buttons referred to in tasks are on the remote control.
Turning on your TV
To turn your TV on or off:
1 Make sure that the antenna or cable TV system is connected, and the TV is plugged
into a power outlet.
2 Press the (power) button on the TV or POWER on the remote control to turn on
the TV.
Warning: The AC plug supplied with this TV is polarized to help minimize the possibility of
electric shock. If the polarized AC cord does not fit into a non-polarized AC outlet, do not
file or cut the blade. It is your responsibility to have an electrician replace the obsolete
outlet. Do not use this plug with an extension cord or other outlet unless the blades can be
fully inserted.
3 Press the (power) button on the TV or POWER on the remote control again to turn
off the TV.
Note: You can set the TV to turn off automatically by setting the SLEEP timer. In TV mode, the
TV will turn off automatically if there is no input signal for 15 minutes. After you turn off
the TV, you should wait at least 5 seconds before you turn it on again.
Selecting a channel
For information on channel numbering, see “Understanding US channel numbering” on
page 17.
To select a channel:
•Press CH – or CH + on the remote control to go to the next lower or higher channel
(after the channels have been memorized. See “Setting up the channels” on page 18).
Or
Press the number buttons to select a channel (for example, if you want channel 83,
press 8, then press 3).
Or
Press RECALL to go to the last viewed channel.
Understanding US channel numbering
Most digital TV channels have more than one channel. The main channel carries the signal
for the main TV program. The sub-channels carry signals for additional or alternate
programming, such as a radio or news broadcast.
For example, if the main channel number is 8, the sub-channel number might be 8-1, 8-2, or
8-3.
To select a sub-channel:
1 Press the number buttons for the main channel (for example 8).
2 Press the • button, then press the sub-channel button (for example 1).