Filter
Top Products
Using your T
V
19
Skipping unwanted channels
After saving channels into memory, you can eliminate unwanted channels from memory so
that only the channels you want to watch are selected with the CH+ or CH– buttons.
To delete a memorized analog channel:
1 Tune to the channel you want to delete.
2 Press MENU on the TV or remote control. The on-screen display (OSD) opens.
3 Press VOL+ or VOL– to select CHANNEL, then press CH –. The CHANNEL menu opens.
4 Press CH + or CH – to select SKIP, then press VOL+ or VOL– to select ON.
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
5 Press MENU one or more times to close the OSD.
To delete a memorized digital channel:
1 Tune to the channel you want to delete.
2 Press CH.LIST to open the CHANNEL LIST screen.
3 Press CH + or CH – to select SKIP, then press VOL+ to select ON.
Tip: You can add a channel to memory by using the number buttons to enter the channel
number, then completing the steps for deleting a channel and setting the SKIP option to
OFF.
4 Press MENU one or more times to close the OSD.
Selecting a different signal source
This TV has one group of AV input terminals, an S-VIDEO input terminal, and set of
Component input terminals to enable connection to a DVD, VCR, or other video equipment.
For information on connecting your TV to other video equipment, see “Connecting to other
equipment” on page 16.
To select a different signal source:
•Press INPUT repeatedly to cycle through the available input sources. The input sources
will be shown on the screen as they are selected.
Note: The S-VIDEO input uses the same circuit as VIDEO. If both S-VIDEO and VIDEO inputs
are connected, the S-VIDEO signal overrides the VIDEO signal and S-VIDEO is shown on the
screen. To watch the VIDEO input, disconnect the S-Video cable.
To watch TV again, press INPUT until the TV program is shown on the screen.