Be d Re d e f i n e R
Op e R a t O R 's Ma n u a l
17
8. If shield clogs with mud or debris, do not hit unit against hard
surfaces to clean, or damage to unit may occur. Stop engine and
unclog shield with a suitable tool.
IMPORTANT
Be sure blade has completely stopped spinning before setting unit
on concrete or other hard surface. Never allow spinning blade to
contact hard surfaces. Carbide teeth on blade can break, or damage
to surface can occur.
warning
The complete unit, specically the drive shaft assembly and mufer
exhaust area may become very hot during use. Avoid contact during
and immediately after operation, otherwise serious personal injury
may result.
e d g I n g o p e r a t I o n
warning
Before edging, be sure to read and understand the entire Operator’s
Manual and Safety Manual to avoid the chance of serious personal
injury.
1. Before edging, water the area to soften the ground to make edging
easier.
2. Before edging, check the area and remove all obstacles and objects
that could be thrown.
3. Plan to edge regularly to make it easier to keep a neat edge and to
avoid having to make more than one pass.
warning
Never adjust blade height or clear debris from shield with engine
running, otherwise serious personal injury may result.