Filter
Top Products
19
BASIC OPERATION
TURNING ON THE PROJECTOR
1
Complete the peripheral connections (with Computer, VCR, etc.)
before turning on the projector. (Refer to “CONNECTING TO
THE PROJECTOR” on Pages 11~-13 for connecting that
equipment.)
2
Connect the projector’s AC Power Cord into a wall outlet. The
LAMP indicator lights RED, and the READY indicator lights
GREEN.
3
Press the power ON-OFF button on the Remote Control
Unit or on the Top Control to ON. The LAMP indicator dims,
and the Cooling Fans start to operate. The Preparation Display
appears on the screen and the count-down starts. The signal
from the source appears after 30 seconds.
TURNING OFF THE PROJECTOR
1
Press the power ON-OFF button on the Remote Control Unit
or on the Top Control, and the message “Power off?” appears
on the screen.
2
Press the power ON-OFF button again to turn off the projector.
The LAMP indicator lights bright and the READY indicator turns
off. The Cooling Fans operate for 90 seconds after the projector is
turned off. (During this “Cooling Down” period, this appliance
cannot be turned on.)
3
When the projector has cooled down, the READY indicator turns to green
again and you can turn the projector on. After cooling down completely,
disconnect the AC power cord.
When the Power Management function is ON, the Projector detects the signal interruption and turns the Projection
Lamp off automatically. Refer to “Power Management” on page 33.
When the TEMPERATURE WARNING indicator flashes red, the projector is automatically turned off. Wait at least 5
minutes before turning the projector on again.
When the TEMPERATURE WARNING indicator continues to flash, follow procedures below:
1.Press the power ON-OFF button to turn off the projector and disconnect the AC power cord from the AC outlet.
2. Check the air filters for dust accumulation.
3.Clean the Air Filter. (See “AIR FILTER CARE AND CLEANING” section on page 35.)
4.Press the power ON-OFF button to turn it on.
If the TEMPERATURE WARNING indicator should still continue to flash, contact the sales dealer where you
purchased this projector or service center.
NOTE: The Cooling Fan may work for cooling while the projector is turned off. When the Cooling Fan
is working, TEMPERATURE WARNING INDICATOR flashes red.