Filter
Top Products
Antenna Installation 3-13
Connecting the Antenna Cables
Connecting the Antenna Cables
To connect your RoamAbout Access Point to an outdoor antenna
installation, you need the following components pictured on the right side
of this page:
A = RoamAbout Pigtail Connection (50 cm)
B = RoamAbout Lightning Protector
C = Low-Loss Antenna Cable
D = Outdoor Antenna Cable
The Pigtail Connection (A) connects the PC Card to the Lightning Protector
(B).
Antenna Cable Route
Shortening the antenna cables voids the Warranty and may conflict with
radio certifications and/or approvals.
The cable should not be installed into tight positions, as bending or applying
excessive force to the connectors may damage the antenna cable. Always
allow the cable to bend naturally around corners. The recommended bend
radius is 25 mm (1 in.).
The low-loss antenna cable must be secured along its complete length. No
part of the cable should be allowed to hang free. This is particularly
important for cable parts that are installed outdoors. The antenna cables and
cable connectors are not designed to withstand excessive force:
• Do not use connectors as cable grips to pull cable through raceways or conduits.
• Do not use cable connectors to support the weight of the cable during or after
installation.
• Do not use tools to tighten connectors (finger-tighten only).
D
C
B
A