Filter
Top Products
13
Changing settings
Press the MENU button until the item you wish to
change appears.
1
The GUI indicator lights.
The display indication changes with each press of the MENU
button.
<
The D-03 exits the setup mode when it is left idle for 10
seconds or more.
W_OUT
Select a word frequency (kHz) when the WORD button is set
to “W_OUT”. The factory default is 44.1 kHz.
CH_SEL
Select channel received when INPUT is set to i.LINK.
L/R is the factory default.
L/R: front left and right
C/LFE: center and subwoofer
LS/RS: surround left and right
The select channel icons light.
The icons flash when the selected channels do not reflect
input signals. In this event, change channels or check digital
device connections.
(Normal display)
This exits the setup mode.
44.1 88.2 176(176.4)
96
48192100
Use the SELECT button to change settings.
2
Press the MENU button (or leave the unit idle for 10
seconds) to end settings.
3
Press the MENU button once or twice to exit the setup mode
and return to the normal display.
Restoring factory default settings
Made settings persist on a semipermanent basis even when
the power plug is disconnected.
Use the following procedure to clear all settings and restore
the unit to the factory defaults.
1. Turn the unit off.
If the unit is on, turn off the unit and wait 30 seconds.
2. Press the POWER switch while holding down the
FILTER button.
Hold down the FILTER button until the unit is powered up
and the display lights.