Filter
Top Products
14
Major settings Messages
“- - -“ appears on the right side of the display.
An incompatible signal is input.
Do not input signals other than PCM or DSD.
Check digital device connections.
XLR, XLR2, DUAL, RCA1, RCA2, OPT or i.LINK flashes.
The unit cannot detect a digital signal. Press the INPUT button
to select a terminal to which a digital device is connected.
Turn on the connected device. Confirm the settings of the
connected device.
LOOP ERR!
The i.LINK connection has been connected to form a loop.
NO WORD!
No WORD clock signal is being input.
UNKNOWN
The device connected via i.LINK is not known.
WORD ERROR!
The frequency of the input source does not match word
frequency. Select 44.1, 88.2 or 176.4 kHz during Super Audio
CD playback.
WRD LCKING
Indicates that the input WORD clock signal is locked.
WRD UNLCK!
Indicates that the device cannot lock to the input WORD clock
signal. Confirm the frequency setting of the connected clock
generator. Connect a clock generator whose frequency range
with a precision greater than ±5 ppm.
The L and R channel icons flash.
Indicates that L and R have been reversed in a connection to a
Dual AES compatible device. Correct the XLR cable
connection.
<
Normally, the display shows the current input or the device
name of connected devices while the right side shows the
sampling frequency of input digital signal during CD playback
or “DSD” during Super Audio CD playback.
<
“F” appears to the right of the Fs (frequency) indication when
the i.LINK flow rate control is operating.
The following examples describe settings when the D-03 is
used with the P-01, P-03, G-0 and G-0s.
Connection using i.LINK cables
Setting of the P-01
Output button IEEE 1394
WORD button
IN
(When the G-0s is connected, “Rb IN”)
UP CONVERT button 176.4/192
Setting of the P-03
Digital Output setting i.LINK
WORD button
ON
Setting of the D-03
INPUT button i.LINK
WORD button One of the D-03 that outputs word
synchronization signals: “OUT”
The others: “IN”
When the G-0 is connected, set all
the D-03s to “IN”.
W_OUT setting 176.4 or 88.2
CH_SEL setting respective channels
Setting of the G-0/G-0s
Frequency change button (A, B or C) 176.4 kHz or 88.2 kHz
FREQUENCY MODE button 44.1kHz
Connection using XLR digital cables
Setting of the P-01
Output button XLR DUAL
WORD button
IN
(When the G-0s is connected, “Rb IN”)
UP CONVERT button 176.4/192
Setting of the P-03
Digital Output setting DUAL
WORD button
ON
UP CONVERT button 176.4 or DSD
Setting of the D-03
INPUT button DUAL
WORD button One of the D-03 that outputs word
synchronization signals: “OUT”
The others: “IN”
When the G-0 is connected, set all
the D-03s to “IN”.
W_OUT setting 176.4 or 88.2
CH_SEL setting respective channels
Setting of the G-0/G-0s
Frequency change button (A, B or C) 176.4 kHz or 88.2 kHz
FREQUENCY MODE button 44.1kHz