Filter
Top Products
17
*Trademark
Getting Started
7
To test codes, point the
remote towards the device
and press keys like
“POWER”, “VOL”, “CHAN”,
etc. Or, to access keys such
as “PLAY”, “STOP”,
“SLEEP”, etc. see the first
note below.
If the keys respond, highlight
Yes and press the SELECT
key, then go to step 8.
If the keys do not respond,
highlight No and press the
SELECT key. (repeat step 7
to test the next code)
If the keys you want to test
are not on the remote,
access the Extended
Function Screen by pressing
the ADVANCED key and
follow step 7b.
Note Most devices can be tested using the “hard” keys on the remote like
“POWER”, “VOL”, “CHAN” etc. However, depending on the device, such as
stereo receivers, CD players, digital tape players, etc., you may be required
to access the Extended Function Screen because the hard keys are not on
the remote (i.e. Play, Stop, Menu, Contrast, etc.). (see step 7b)
Setup Remote Control
Note There is a possibility that more than one code will work when setting up your
device. After you have completed setup, if you cannot find a function in
the Extended Function Screens, remove the device and try setting up the
device again using a different code.