Filter
Top Products
OSD Timer
0-255 (30 default)
LCD Timer
6-255 (40 Default)
Note: setting the timer to 5 or lower sets the LCD
backlight to Always On.
Set: RS232 Echo
On (Default) /Off
Allows RSR232 characters to be sent back to
the controller.
Set: Restore Factory
Are You Sure? - Press Enter Key
Use this Function only in the event that
the processor no longer functions properly and
all other system checks have been performed.
This command will erase all custom settings
and restore the original firmware configuration.
Be sure to go back through the Setup procedure
for proper operation.
The next step in the setup procedure is to align the
display device. Be sure to follow all
directions for setting up the display found
in the display’s manual. Using a test DVD
with the Safe Area test pattern, align the image
size, position and blanking first using the controls
found in the display device. Only use these controls
in the DVP1500 if the display device does not offer
these controls or if there is not enough range.
IR REMOTE AND
OSD OPERATION
The DVP1500 is shipped with a Infrared remote
control that allows for direct access to most
commands used to control the processor.
Adjustments can be made by either pressing the
appropriate button on the remote or by toggling
through the On-Screen-Display (OSD).
This is a learning remote that contains the codes for
Faroudja processors and display systems. The
remote can be programmed to handle other devices
as well. See the separate manual for instructions on
programming this remote.
ON SCREEN DISPLAY (OSD)
Accessing the OSD
• Press Menu button to bring up main Index.
• Use Function Up/Down Keys until the triangle
at the top of the OSD turns yellow.
• Use the Left/Right keys to move to the next
menu page. A list of available Functions
will appear.
• Press Function Up/Down keys to select
an adjustment.
• Use Value Left/Right keys to adjust.
The main menu drops away and a single
line menu appears.
• Use the Function keys to return to the drop
down menu.
• The OSD will time out after 8 seconds.
Note: Unused inputs can be deactivated for simpler
operation of the processor. See the Setup
instructions for details.
6
IR REMOTE / OSD
Touch screen panel
Function / Value Keys
Store / Enter Key
The remote has four screens with the different commands.
Number pad: allows
for entering specific
level numbers
(Contrast + ###),
or access to added
Profiles P7 & P8
(Profiles + 7 or 8).
Access OSD Menu
Select Inputs
Note: Press the
DVD key two
times to select
Recall Profiles
Note: To recall a
profile, Press
Profile + P1-P6
Press Profile + Fact Recall to
reset picture level settings to
the factory position.
Aspect Ratio select
Image Adjustments