Filter
Top Products
ALTERNATIVE CABLE TV CONNECTIONS
Cable converter/decoder output channel setup
1 Be sure the cable connections are correct.
(See page 12.)
2 Turn on the TV, VCR and cable converter/decoder.
3 Set the TV to channel 3 or 4.
4 Press the VCR button on the remote control to select
the VCR operation mode.
5 If the VCR indicator is off, press the TV/VCR button
on the remote control.
The VCR indicator lights.
NOTE: If the initial setup has not yet been
completed, the “Auto Setup” message will appear. In
that case, first follow steps 5 – 7 under “INITIAL
SETUP” on page 15.
6 Press the MENU button on the remote control.
The main MENU appears.
@@@@@@@@@MENU
Timer@program
VCR@setup
Clock@set
Language@select
Rec.List@super
Auto@tuning@memory
[CH§‡]†Select
[SET]†OK@@@@@@[MENU]†TV
7 Press the CH/TRACK l (or j) button to select the
VCR setup option, then press the SET button.
The VCR setup menu appears.
CATV/TV@@@@@@@…CATV@TV
Cable@box@@@@@…No@@@Ch02
MTS@@@@@@@@@…ST@SAP@Mono
Audio@out@@@…ST@L@R@Mono
Child@Lock@@@@@On@@…Off
Off@timer@@@…Off@2Hr@6Hr
Auto@AV@Select@On@@…Off
[CH§‡]†Option
[SET]†Select@@[MENU]†TV
8 Press the CH/TRACK l (or j) button to select the
Cable box option.
9 Press the SET button to set your cable
converter/decoder output channel. The output
channel should be indicated on the cable
converter/decoder back panel. If not, please refer to
the cable converter/decoder instruction manual for
details.
Press the
SET
button repeatedly. Each time you
press the button, the selection changes:
No
→
Ch02
→
Ch03 ... Ch07.
The selection is indicated by the “
z
” next to it.
NOTE: Select “No” if you are not using the cable box.
F When finished, press the MENU button to exit the
menu display.
IMPORTANT NOTES:
When the cable converter/decoder output channel is
selected as described above,
œ The VCR tuner remains set to receive the same
channel as the output channel of the cable
converter/decoder. Auto channel programming and
manual channel selection using the VCR tuner are
not possible.
œ If you turn on the cable converter/decoder after
turning on the VCR, no image will appear on the TV
screen. In this case, turn off the VCR, then turn it on
again.
œ Leave the cable converter/decoder on until timer
recording is complete.
œ For timer recordings, you must select the channel to
be recorded using the channel selector on the cable
converter/decoder.
SU4H/UF2 (FVH-T619 GB) Tue. Mar. 09/1999
13