Flying Pig Systems FireBallTM FP-1 Universal Remote User Manual


  Open as PDF
of 77
 
PAGE 50
FireBall™ FP-1 User’s Manual
ENABLING PASSWORD PROTECTION
Optional Password Protection enables you to limit user access to the Setup Menus. This is useful to
lock out the ability to change the global user settings and preferences.
Setting a System Password – Follow these steps to setup a new system password:
1. Using the remote control, enter a 4 to 8 digit code into the password field.
2. Press the SELECT key to highlight the VERIFY field.
3. Re-enter the same password for verification.
4. Press the SELECT key to highlight the SAVE button.
5. Press SELECT again to save your password and enable Password Protection on the Setup
Menus.
• YoumustexitSetupandre-entersetuptoactivatethepasswordprotection.
• Ifauserpasswordisspecified,youwillbepromptedforyourpasswordwheneveryoupress
the Setup key on the remote.
• Ifthepasswordenteredmatchesthestoredpassword,fullaccessisgrantedtotheuseruntil
the next power off cycle.
• Ifthepassworddoesnotmatch,theuserwillbeasked2moretimestoenterthecorrect
password. If after the third try the password still does not match, the system will not allow the
user access to the Setup menus.
• IftheuserdoesnotspecifyaSystemPassword,accesstotheSetupmenuswillbeallowed
whenever you press the Setup key.
Removing a System Password – Follow these steps to remove the system password:
1. Press the SETUP key and enter your existing system password.
2. Highlight the CLEAR button on screen and press the SELECT key on your remote.
3. The password and verify fields will be cleared.
4. Highlight the SAVE button and press SELECT.
YouwillnowbeabletoenterSetupwithoutenteringapassword.
 previous next