Filter
Top Products
22
9. Installation
9.1 Welcome to Fortec Star HD World
y The very first time you turn your receiver on, or after a
Factory Reset, the language selection menu appears on
your TV screen.
y Use the e/f/▲/▼ buttons to select the language.
y Press OK button to go to next step.
9.2 How to Set Up your Antenna
9.2.1 Antenna Settings
y Select the satellite by pressing e/f buttons and choose
from the list.
y Select your LNB type using thee/f buttons.
y Select the correct DiSEqC setting for your antenna. If
you have a single antenna, chose OFF. Otherwise,
chose the corresponding DiSEqC output.
y Select DiSEqC 1.1 setting if you are using 4 or more
LNB’s.
y Choose an active TP for the selected satellite (You will
only get a signal from an active TP. If in doubt, please
check www.lyngsat.com
or www.satcodx.com for a TP
that is broadcasting a channel. These Web sites provide a full list of all satellites and the
channels available on each satellite.)
y Use Power ON if the receiver is going to feed the LNB. (This is typically the case.)
y Select DiSEqC 1.2 or USALS if you are going to use a motor. If so, after selecting it press OK in
order to set up the motor parameters.
y If the setting is completed, your antenna is set up properly and pointed correctly to the selected
satellite the two bars will show the level and quality of the signal.
y Save the current setting using the Red button on the remote control.