Filter
Top Products
25
9.3.3 Advanced Scan Function
• To access the Advanced Scan menu from the
Antenna Setup, press the WHITE button on the
remote control.
• In this menu, you can scan a specific transponder
from the list.
• You can scan a new transponder as well by adding its
frequency, symbol rate, and polarity.
• Select the satellite by using thee/f buttons. Choose
from the list and confirm the selection with OK.
• Select the TP by using e/fbuttons. Choose from the
list and confirm the selection with OK.
• If you need to search for a TP which is not in the data,
input a proper frequency using NUMERIC buttons.
o Symbol Rate: Input a proper symbol rate if
needed using the Numeric buttons.
o DVB Standard: Select the DVB Standard of
the TP (DVB-S or DVB-S2) using e/fbuttons.
o Please refer to following table for selection for
Modulation, FEC, Pilot in DVB-S or DVB-S2.
Parameter DVB-S DVB-S2
Modulation Disabled QPSK 8PSK
FEC
Auto,1/2,2/3,
3/4,5/6,7/8
1/2,2/3,3/4,3/5,4/5,
5/6,8/9,9/10
2/3,3/4,3/5,
5/6,8/9,9/10
Pilot Disabled Auto, off, on Auto, off, on
• If you know the PID channel information you can scan for a specific channel.
Enter the PID of the channel you want to search.
Set the channel's Video PID using Numeric buttons.
Set the channel's Audio PID using Numeric buttons.
Set the channel's PCR PID using Numeric buttons.
Press the RED button to save.
Press the YELLOW button to start the scan.
Press the MENU button to return to viewing mode or Back( ) button to return to
previous menu.