Filter
Top Products
120
D-108 Owner’s Manual (Changing the initial setting <SETUP mode>)
Bar/Beat Resolution Mode Setting ("Resolution ? ")
This mode sets up the display resolution mode in either “ON” or “OFF”.
If you set this mode to “ON”, the D-108 will register the memory points rounding up or down so that clock digits are always kept at
00. This mode is only relevant when you choose Bar/Beat/Clock as a time base.
This function is very useful for edit functions such as copy paste or move paste when you use the Bar/Beat/Clock as the time base.
For example, when you register a memory point that picks up a real time in play mode, you press the STORE button and then some
memory keys. The position you choose will be automatically corrected based on the Bar/Beat resolution. The position will always
register in clock accuracy. This setting is memorized even when the power is off.
* Initial setting : Off
* Available setting : Off, On
* This setting is commonly applicable to all the programs.
* This setting cannot be saved or loaded.
* The setting is memorized even when the power is off.
* For example, if you are to register 001 bar 1 beat 46 clock to the CLIP BOARD IN point and 002 bar 4 beat 51 clock to the
CLIP BOARD OUT point, if the resolution mode is set, the actual memory will be corrected in the following key.
This example is mentioned based on the time signature of a 4/4 beat.
001 bar 1 beat 46 clock -> 001 bar 1 beat 00 clock : round down on clock
002 bar 4 beat 51 clock -> 003 bar 1 beat 00 clock : round up on clock
1. Press the DISP SEL key and choose the flashing SETUP
mode on the display. Then, press the EXECUTE/YES key.
The SETUP display stops flashing.
2. With the JOG dial, choose “Resolution?”.
The “?” display will start flashing. The display will also show
the current setting. In the case of the initial setting, it will
show “Off”.
3. Press the EXECUTE/YES key.
The current setting will start flashing which indicates it is
ready to change setting.
4. With the JOG dial, choose either “On” or “Off”.
If you choose “Off”, the slave function will not work.
If you choose “On”, the clock will be rounded up or down
always ending in 00.
5. Press EXECUTE/YES key after choosing the setting you
want.
The display will go back to the display of item 2.
* Press either the STOP button or EXIT/NO key to return
from the second step menu to the first or to quit SETUP
mode. The menu will go backwards each time you press
either key so that you can correct the setting, choose some
other SETUP mode or eventually return to the normal time
base display.
44.1kHz
SETUP
87654321
42
OL
0
30
24
18
12
9
6
3
∞
44.1kHz
SETUP
87654321
42
OL
0
30
24
18
12
9
6
3
∞
MIDI Device ID Setting ("Device ID ? ")
This mode sets up the MIDI device ID number on the D-108.
The set ID applies to both receiving and transmitting when an external sequence software controls the D-108 via MMC or the Fostex
system Exclusive Message. This mode is necessary to arm the slave machine record track selectors from the master machine.
The available device ID is between 00 and 99. But, if the D-108 receives a message with ID No 7F, The D-108 will recognize it and
follow the command regardless of the device ID setting.
* Initial setting : 00
* Available setting : 00 ~ 99
* This setting is applicable to all programs.
* This setting cannot be saved or loaded.
* The setting is memorized even when the power is off.