Filter
Top Products
D-108 Owner's Manual (Names and Functions)
18
44.1kHz
SETUP
8
7
6
5
4
32
1
MTC IN
OFFSET
CHASE
LOCATE
PGM
REMAIN
FORMAT
SIGNATURE
TEMPO
48kHz
-0.1%
COMPLETED!
SURE?
MIDI
CHASE
SAVE
LOAD
EXT SYNC
DIGITAL
MTC IN
ABS
42
OL
0
30
24
18
12
9
6
3
∞
2. Preset Display
The display below shows all preset items for explanation purpose.
44.1kHz
87654321
42
OL
0
30
24
18
12
9
6
3
∞
44.1kHz
8
7
6
5
4
32
1
ABS
42
OL
0
30
24
18
12
9
6
3
∞
Level meter
The level meter shows
the recorder output
level and the recording
level for track 1-8.
Track indications
The track indication blinks when the corresponding
track is ready. It turns off when the track is safe, and
is lit during recording.
ABS
MTC
SIGNATURE
LOCATE
REMAIN
MTC IN
MTC OFFSET
CHASE
PGM
35 dot message display
This display indicates the ABS time, MTC time value or bar/
beat/clock value, and a parameter name in the SETUP mode.
<Display Section>
The D-108 display integrates the level meter of a high-visibility FL tube with a 16 digits and 35 dot message display.
The level meter shows the Track 1-8 output level of the recorder section. The time display shows the current time of the
recorder section using ABS TIME (Absolute time), MTC (MIDI time code), or MIDI BAR/BEAT (bar/beat). This display also
shows messages required for interactive operation. The following section explains the display functions and provides
with some examples.
1. Display shown when the power is turned on
When you turn on the power to the D-108 and the connected E-IDE hard disk, or external SCSI drive (a formatted
removable disk or hard disk), the display shows the [Initializing...] message, [Current Dr], the name of the connected
current drive, then recording mode (8track mode, etc.), and finally the top position of the disk in the time base
(ABS, MTC, or BAR/BEAT/CLK) used in the last Program before you turned the power off.
The following example indicates that the D-108 started with the ABS Time Base used in Program 1.
Name of the
connected current
drive
Lights up when ABS is selected as Time
Base.
Lights up when MTC is selected as Time
Base.
Lights up to indicate a bar/beat/clock value
when BAR/BEAT/CLK is selected as Time
Base.
Lights up when the D-108 enters data edit
mode, enabling you to edit data. Pressing
the LOCATE key while this indicate is lit will
cause the D-108 to locate the position of the
displayed time or the bar/beat/clock value.
Lights up to indicate available recording time
and space on the disk.
With the optional Model 8345 TC/SYNC card
installed, this will be lit when MTC or LTC is
externally input.
Lights up when MTC Offset menu is selected
in SETUP mode.
Flashes when Slave mode in SETUP mode
is turned on. When a signal is locked, the
flashing indicator lights up steadily.
Lights up to indicate the current Program
number.