Filter
Top Products
D-108 Owner’s Manual (Storing a Locate Point <Edit Point>)
56
Editing and storing locate data
If you know the position of the desired locate point, follow the steps below.
Editing and storing data
You can recall data stored in the memory key, edit it, and store it. again
• Press the STORE key instead of the HOLD/> key in
Step 1 and omit Step 3 to speed operation.
4
2
3
8 TRACK DIGITAL RECORDER
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE
REHEARSAL
TAK E
TIME BASE SEL
RECALLSTOREHOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDOUNDOERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUTINAUTO PLAY
AUTO PUNCH
START OUTIN END
TC INLOCKED HD ACCESS
RECORD TRACK
1/9
2/10
3/11
4/12 5/13 6/14
7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
POWER
OPTICAL
1, 2
1. Press the HOLD/> key while the D-108 is stopped.
The currently-displayed time value (or bar/beat/clock value)
is captured and the D-108 enters data edit mode.
2. Press the HOLD/> key, or turn the SHUTTLE dial to
move the flashing cursor on the time value digit, and
use the JOG dial to increase or decrease the value.
3. Press the STORE key.
The [Press LOCATE: ##] menu will appear as indicated
before. Ignore this go to the next step.
4. Press the desired memory key.
The STORE LED turns off.
The input time value (or bar/beat/clock value) is stored
in the corresponding memory key.
1, 4
2
3
8 TRACK DIGITAL RECORDER
PREVIEW
ENVELOPE
LOCATE REC END
VARI PITCH
RECORD STOP PLAY REWIND F FWD
PUNCH LOCATE
REHEARSAL
TAKE
TIME BASE SEL
RECALLSTOREHOLD/
/NO
EXIT
/YES
EXECUTE
DISP SEL
REDOUNDOERASE
AUTO RTN
COPY MOVE PASTE
CLIPBOARD
AUTO RTN
OUTINAUTO PLAY
AUTO PUNCH
START OUTIN END
TC INLOCKED HD ACCESS
RECORD TRACK
1/9
2/10
3/11
4/12 5/13 6/14
7/15 8/16
PGM SEL
PUNCH
IN / OUT
LOCATE ABS 0
CLIPBOARD PLAY
AUTO
SHIFT
POWER
OPTICAL
2
3. Press the STORE key.
The [Press LOCATE: ##] menu will appear as indicated
before. Ignore this go to the next step.
4. Press the memory key that you pressed in Step 1
again.
The STORE LED will turn off. The edited data is stored,
and the D-108 displays the previous Time Base indication.
1. While the D-108 is stopped, press the memory key
that stores the data you wish to edit.
The stored data appears on the display and the D-108
enters data edit mode.
2. Press the HOLD/> key, or turn the SHUTTLE dial to
move the flashing cursor to the time value digit, and
use the JOG dial to increase or decrease the value.