Filter
Top Products
9
EN
1A23
CONNECTIONS
CONNECTIONS
Connecting an Antenna
Basic Connection:
AUDIO OUT
RL
VIDEO
ANT. IN
OUT
ANT. ΟUΤ
Rear panel of STB
RF cable
VHF/UHF
antenna
When Connecting to Cable Box (optional) Also:
AUDIO OUT
RL
VIDEO
ANT. IN
OUT
ANT. ΟUΤ
Cable box (optional)
ANT
IN
ANT
OUT
Rear panel of STB
Incoming cable
signals
RF cable
To audio/video input
jacks of the TV
RF cable
VHF/UHF
antenna
Refer to following
pages for the
connection to TV.
RF cable
To antenna
input jack
Supplied cables used in this connection are as follows:
•
RF cable x1
Please purchase the rest of the necessary cables at your local store.
Before connecting, ensure the AC power cords of all devices are NOT
connected to the AC outlets.
1 Use an RF cable to connect the antenna to the ANT. IN jack on the
STB.
2 Use an RF cable to connect the incoming cable to the antenna
input jack on the cable box.
3 Use an RF cable to connect the antenna output jack on the cable
box to the antenna input jack on the TV.
4 Refer to “Connecting to TV” on page 10 to connect your TV.
Note to the Cable TV System
Installer:
This reminder is provided to call
the Cable TV system installer’s
attention to Article 820-40 of
the National Electrical Code,
which provides guidelines for
proper grounding - in particular,
specifying that the cable ground
shall be connected to the
grounding system of the building,
as close to the point of cable entry
as possible.
NOTE:
•
When you connect the RF cable to another device, be sure to use a splitter as shown below.
Splitter
e.g., VCR
STB
To RF-IN
To ANT. IN
Another device
VHF/UHF
antenna
X6040UD_Book.indb 9X6040UD_Book.indb 9 10/22/2007 5:09:12 PM10/22/2007 5:09:12 PM