Filter
Top Products
3-1
CHAPTER 3 INSTALLATION
1. INSTALLATION
1) General notes on installation
This equipment provides its intended function only when it is installed properly. The installation
site is important for proper operation and continued performance. Select it keeping the following
points in mind.
(1) Select a place where the unit can be observed and operated directly.
(2) Keep away from water spray.
(3) Select a clean and cool place.
(4) Select a place where shock, vibration and noise are minimal.
(5) Observe the following compass safe distance to prevent interference to a magnetic
compass:
Standard compass: 1.10 m
Steering compass: 0.80 m
NOTE
FURUNO will not assume responsibility for damage caused
by water spray.
2) Mounting the unit
The equipment can be mounted on the underside of table or a table top. Ensure the mounting
location is strong enough to support the unit under the condition of shock and vibration normally
encountered onboard the vessel. If necessary, reinforce the mounting location with a lining block
or doubling plate.
Underside of table Table to
p