Filter
Top Products
Please Note: Z-Wave home control networks are designed to work
properly alongside 802.11 wireless computer networks, Bluetooth
and other 2.4GHz or 5.8GHz devices. Some baby cams, wireless video
devices and older cordless phones using the 900MHz frequency range
may cause interference and limit Z-Wave functionality. Many 900MHz
products have a switch to select channel “A” or “B”. You may find that
one of these channels will cause less interference than the other.
NOTES ON NETWORK MANAGEMENT
Add a node, group or scene can also be referred to as include a
node, group or scene. Remove a node, group or scene can also be
referred to as Exclude a node, group or scene.
If the screen displays FAILURE during the setup or programming
process, you have pressed an invalid key or the desired action has
not been successfully completed. Please make sure the remote is
within two feet of the device and try again.
ADDING A DEVICE (NODE/LIGHT) TO THE NETWORK
In order to control the lights, they must be Z-Wave enabled and you must
first add them to your home network. There are two ways to do this.
Add lights to your remote so that they can be controlled individually
using the number keys (maximum of 18). Adding a device to your
remote also adds it to your network. If the device number you are
trying to add is already associated with another device, the previous
information is lost.
Add devices to your home network without assigning them to a
specific number key. These devices can only be controlled through
the GROUP, SCENE or ALL commands.
To add a device to your home network WITHOUT assigning it to a
specific number key:
Press and hold SETUP until the screen shows LGHT SETU.P
Press and Release OK and the screen will display ADD.
Press OK once; the screen will now display TO NETWORK.
Press OK and the screen will display SETUP WAITING.
Press the button on the device so that it communicates with the
remote.
The screen will display SUCCESS to indicate that the Node/Light has
been successfully added.
The device can now be added to Groups and/or Scenes.
To add a device to your home network and assign it to a specific
number key:
Press and hold SETUP until screen displays LGHT SETUP.
Press OK and the screen will display ADD.
Press OK and the screen will display TO NETWORK.
Use either Arrow key to scroll until the display reads TO A KEY and
then press OK.
1.
2.
1.
2.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.