Filter
Top Products
Figure 31
Workpiece
Workpiece
Center
Pencil Lines
Marked Diagonally
Across Corners
Figure 32.
Figure 31.
To set up a spindle turning operation:
1.
Figure 32
2.
3.
4.
Step 1
5.
Spindle Turning
Before beginning any turning operation
that uses the live center installed into the
tailstock quill, make sure the spur and
live centers are properly aligned (refer to
Aligning Centers on Page 33 for detailed
instructions). Failure to head this warning
could result in the workpiece being thrown
from the lathe resulting in death or serious
personal injury.