Filter
Top Products
Figure 37.
Figure 35.
Figure 35
3.
Using a Backing Block
To mount your workpiece to a backing block:
1.
2.
3.
4.
Note: Allow the glue joint to completely cure
according to the manufacturer's instructions.
5.
Attaching Faceplate to Workpiece
1.
Spindle Turning
Page 24
Note: Cut off the excess corners of the
workpiece to make it as close to "round" as
possible.
2. Step 1
Figure 37
NOTICE
DO NOT use screws with tapered heads
to attach the faceplate because they could
split the faceplate, or the screws could
snap off during operation. See the illustra-
tion in Figure 36 for examples.
Figure 36.
Faceplate Turning