Filter
Top Products
- 22 -
- 22 -
Setting the stuffing (only Bx…A)
SR=6900 (= “number 1”):
Active output symbol rate
Bx 1A
SR=6900 (6531)
STUFFING:
Zahl 1 Zahl 2
Number 1 Number 2
(6531) (= “number 2”):
The current measured output symbol rate.
If the station filter is activated, this value is lower than
the value of the “number 1”. The value fluctuates,
since the data rates of individual stations are dynami-
cally modified by the broadcasters.
•
Use the
▶
◀
/
buttons to place the cursor under the
number to be changed (“number 1”) and set the symbol
rate with the buttons .
The value set corresponds to the new output symbol rate.
Note:
• Increase the value of “number 1”
—> With the station filter “on”/ ”off”, the “number 1” can
be increased to any value up to 7,000.
• Reduce the value of “number 1”.
—> With the station filter “on”, the “number 1” can be
decreased. To do this, observe the “number 2” for
approx. 30 seconds and note the highest value.
Add roughly 10 % to this value. Do not decrease the
“number 1” lower than the value of “number 2”.
Bx 1A
SR=6900 (6531)
STUFFING:
+
–
/
▶
◀
/
* )
M
Kanalzug A
Channel strip A