Filter
Top Products
SKU 94274 For technical questions, please call 1-800-444-3353 PAGE 11
UNPACKING
When unpacking, check to make sure that all the parts and accessories listed on
pages 21 and 22 are included, and the product is intact and undamaged. If any parts
are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For Additional information regarding the parts mentioned in the following
pages, refer to the Assembly Diagrams on pages 21 and 22.
LEFT SIDE
VIEW
RIGHT SIDE
VIEW
BOLT
(42)
BOLT
(42)
BOLT
(42)
BOLT
(42)
BOLT
(42)
BOLT
(42)
FRONT
VIEW
FIGURE F
CABINET LEG
(23)
CABINET LEG
(23)
CABINET
(22)
CABINET
(22)
CAUTION! The Blast Cabinet weighs approximately 250 pounds, and will
require additional assistance and/or a proper lifting device during the assembly
procedures.
Remove all parts from within the Cabinet (22). Then, with assistance, carefully 1.
place the Cabinet upside down on the oor surface. (See Figure F.)
Attach the four Cabinet Legs (23) to the Cabinet (22), using ve Bolts (42) per 2.
Cabinet Leg. NOTE: The front left Cabinet Leg should have a name plate on it.
Each of the two rear Cabinet Legs will also require two Self-Tapping Screws (43).
(See Figure F.)
Once the Cabinet Legs (23) are attached to the Cabinet (22), stand the Cabinet 3.
upright on its Cabinet Legs. (See Figure F.)