Filter
Top Products
SKU 94274 For technical questions, please call 1-800-444-3353 PAGE 14
Attach the Lamp Housing (1) to the top of the Cabinet (22), using the Screws, 8.
Washers, and Nuts (26) provided. NOTE: The two Fluorescent Lamps (3) have
previously been installed in the Lamp Housing by the manufacturer.
LAMP HOUSING
(1)
FIGURE K
The Grate (39) has one small edge covered by a Rubber Strip (40). Place the 9.
Grate inside the Cabinet (22) with the Rubber Strip edge to the right/front of the
Cabinet. (See Figure L.)
GRATE (39)
Prior to use, the Blast Cabinet requires the attachment of a 10. Female Quick
Coupler (not included) to its Air Regulator (9). To do so, wrap approximately 3” of
Pipe Thread Seal Tape (41) around the male threads of the Air Regulator. Then,
rmly tighten the Quick Coupler onto the Air Regulator. (See Figure J.)
RUBBER STRIP (40) HERE
(NOT SHOWN)
RIGHT SIDE
VIEW
FIGURE L