Filter
Top Products
HP High-Definition LCD TV Service Manual 49
Installing the PCA into the Keyboard
The keyboard PCA may not come installed into the keyboard. If not installed, use the following procedure to install:
1 Make sure the connector on the PCA is facing outward so it fits into the slot in the keyboard, and make sure the buttons
on the PCA are facing down and aligned with the buttons on the keyboard.
2 One side of the keyboard has two tabs. Snap the PCA into the slot below the two tabs.
3 While properly aligning the PCA so it is straight in the keyboard, press the PCA down into the slot below the tabs on
the other sides of the keyboard until it snaps into place.
Removing the Infrared Board
1 Remove the one screw securing the infrared board.
2 Lift the infrared board and detach the cable from the connector.