Hitachi 26LD9000TA2 Flat Panel Television User Manual


 
32
FUNCTION (continued)
Size Switching
Each time button of the remote control is pressed, the screen
display size is switched in sequence, and the status will be displayed at
the bottom of the screen.
TV/AV signal input
TV/AV1/AV2/AV3/AV4 /HDMI
4:3
Panoramic
Full
Cinema
You can display the image at optimum condition by selecting display size depending on the current output image as
shown below.
Current Output
Image
(Input Signal)
Display Size To display suitable screen as follows.
4:3 Play a 4:3 image on screen faithfully. Blanking occurs on both sides.
(4:3 Signal)
Panoramic
Play a 4:3 image which enlarges horizontal and vertical size of the
middle in equal scales, and displays both sides appearing much wider.
(Cinema)
Cinema
Play a 21:9 image in 4:3 image (Cinema size) expanding vertically.
*In some case, slight blanking may remain at the top and bottom.
(Squeeze)
Full
Play a 4:3 image faithfully in the standard vertical size and horizontally
squeezed.
Information
Aspect ratio represents horizontal : vertical ratio on screen.
NOTE
The size will fix as Full mode and not change when receiving the AV3,4
component signal, HDMI signal of 720p/50,720p/60,1080i/50,
1080i/60.
9
16
3
16(or 21)
9
4
CAUTION
Using a wide-screen television
z This television has a screen mode selection feature. If an incompatible screen mode is selected to play certain
software, such as a TV program, the image would appear different form the original. Take this into consideration
when making screen mode choices.
z Use of the wide feature displaying enlarged pictures in coffee shops, hotel and other establishments for
commercial or public viewing purposes could infringe on the copyright holder’s right protected by Copyright Law.
z When a normal 4:3 image (not wide screen) is displayed over the entire screen in the Panoramic mode, the
peripheral image may disappear partly and/or appear distorted in some cases. Use 4:3 mode to view the image
reflecting original intention.
Picture Size