TIPS ON REAR PANEL CONNECTIONS
23
S-VIDEO connections are provided for high performance laserdisc players, VCRs etc. that have this feature. Use these connections
in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the AVC Center.
Refer to the operating guide of your other electronic equipment for additional information on connecting your hook-up cables.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output (INPUT: 4 in the
example on page 22). Refer to your VCR operating guide for more information on line input-output connections.
Connect only 1 component (VCR, DVD player, camcorder, etc.) to each input jack.
COMPONENT: Y-P
B
P
R
(Input 1 & 2) connections are provided for high performance components, such as DVD players and set-
top-boxes. Use these connections in place of the standard video connection if your device has this feature.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV’s P
B
input
and the components R-Y output to the TV’s P
R
input.
Your component outputs may be labeled Y-C
B
C
R
. In this case, connect the components C
B
output to the TV’s P
B
input and the
components C
R
output to the TV’s P
R
input.
It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-P
B
P
R
inputs. (See page 43)
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the
Y-P
B
P
R
jacks.
Input 1 can accept component
Y-P
B
P
R
signal only.
Input 2 can accept both component Y-P
B
P
R
and composite video signal.
You may use VIDEO or S-VIDEO inputs to connect to INPUT 3, 4 or 5, but only one of these, VIDEO or S-VIDEO, may be used at
a time for each input. S-VIDEO has priority over VIDEO.
S-VIDEO output may be used for recording only when the input is of S-VIDEO type.