Filter
Top Products
FIRST TIME USE
16
FIRST TIME USE
Antenna Input/Output
The remote control allows you to switch between two separate 75-Ohm RF antenna inputs, ANT A and ANT B.
ANT A input can be displayed as a main picture or sub-picture. ANT B can only be displayed as a main picture.
(ANT B cannot be displayed as a sub-picture.) The antenna output labeled "TO CONVERTER" allows the ANT A
connection to pass directly to a different source such as a cable box, when ANT B is displayed as a main picture.
Audio/Video Inputs 1and 2
The INPUT button will step through each video source and antenna source input each time it is pressed. Use the
audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players,
etc. (If you have mono sound, insert the audio cable into the left channel jack).
NOTE: You may use VIDEO, S-VIDEO, or COMPONENT: Y-CB-CR inputs to connect to INPUT 2, but note that
only one of these may be used at a time.
Monitor Out
These jacks provide fixed audio and video signals which are used for recording.To have S-VIDEO , S-VIDEO
signal needs to be input to INPUT 1 or INPUT 2.
(4) AUDIO TO HI-FI
These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the
stereo can be controlled by the television's main volume.
(5) S-VIDEO INPUTS 1 and 2
Inputs 1 and 2 provide S-Video (Super Video) jacks for connecting equipment with S-Video output capability.
(6) Component: Y-CB-CR INPUT 2
INPUT 2 provides Y-CB-CR jacks for connecting equipment with this capability, such as a DVD.
NOTES:
DO NOT connect standard VIDEO or S-VIDEO to INPUT 2 when using Y-CB-CR input.
When using the Y-CB-CR input jacks, connect your components audio output to the TV's INPUT 2 Left and Right
Audio input jacks.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to
the TV's CB input and the components R-Y output to the TV's CR input.