Filter
Top Products
BOX/SATELLITE FUNCTIONS
36
3. Press the CABLE button on the remote to switch to cable mode.
4. Hold down the CABLE button on the remote, enter the two digit preset code that matched your cable box as
shown on page 27. The remote will turn off your cable box when the correct two digit preset code is entered.
When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after
five seconds, try another two digit preset code.
5. The remote will now control your cable box.
* If you wish to control a Satellite system or Audio equipment, you must follow the remote programming procedure
shown above. You may use only the CABLE button to program these codes, but note that this button may not be
used for more than one component.
NOTES:
1. If your cable box cannot be operated after performing the above procedures, your cable box code has not been
precoded into the remote.
2. In the unlikely event that your cable box cannot be operated after performing the above procedures, please
consult your cable box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your cable box does not have a power function, the remote will issue the CHANNEL UP function.
5. The LST-CH button will act as your audio component's ENTER button if required.
6. The SLEEP button will act as your audio components '100' button if required.