Filter
Top Products
PICTURE-IN-PICTURE (PIP)
32
as the main channel.
When the COMPONENT: Y-CB-CR Input 2 is selected as PIP, it will appear as a blank sub-picture.
PICTURE-IN-PICTURE CONT.
SURF MODE PIP
This feature will automatically scan all active channel numbers (those set in memory) and display them as PIP
sub-pictures, along the right edge of the screen. Press the PIP button a second time to remoe the sub-pictures
from the screen.
NOTE:
1. If no buttons are pressed when in SURF mode, auto-scanning will continuously scan.
2. If a channel is tuned during this SURF scanning, sub-pictues will be removed from the screen.
3. If PARENTAL CONTROL MOVIE/TV RATINGS setting is ON, PIP Surf Mode is deactivated.
4. You must be in ANT A mode for SURF PIP to operate.
(2) SWAP Button
If you wish to switch what is being shown on the main picture to the sub-picture, press the SWAP button.
NOTE:
1. The SWAP button will only operate when SINGLE PIP mode is chosen.
2. The SWAP function will not operate if ANT B input is set as the main channel (ANT B input cannot be displayed
as a sub-picture.
(3) MOVE Button
To move the sub-picture to another corner, press the MOVE button. The sub-picture moves one step
counterclockwise every time the MOVE button is pressed. (Example below illustrates the MOVE operation for
initial shipping conditions. If you have customized a PIP position, the MOVE operation may differ slightly from this
example).
It is also possible to customize the PIP position. To do htis, wati until the On-Screen Display disappears (about
eight seconds) and then use the CURSOR
, , , buttons.