Filter
Top Products
REAR SPEAKER TERMINAL CONNECTIONS - 12 -
REAR SPEAKER TERMINAL CONNECTIONS
Connect after turning the power to the TV OFF.
Press the Right Speaker red button and insert the positive (+) lead wire into the hole below the button. When the
button is released, the wire is locked into place. In the same manner, press the Right Speaker black button and
insert the negative (-) lead wire. Repeat this procedure for the Left Speaker.
CAUTION: Do not short speaker terminals, (do not connect a wire directly across any two
terminals). This could cause damage to your audio outputs or damage your TV in other ways.
CAUTION: Do not connect speakers simultaneously to the Rear Speaker terminal of the
Projection TV and an external amplifier. This could damage both the TV and the speakers. Your TV was designed
to use 8-Ohm speakers only. Any other type may degrade the audio performance of your entertainment system.
TIPS ON REAR PANEL CONNECTIONS
The S-Video connection is provided for high performance laserdisc players, VCRs etc., that have this feature. Use
this connection in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the TV.
Refer to the operating guide of your other electronic equipment for additional information on connecting your
hookup cables.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line
output (INPUT: 1 in the example on page 11.) Refer to your VCR operating guide for more information on "line"