Filter
Top Products
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS - 18 -
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult
your VCR operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
1 VCR Button
This allows the remote to control your VCR by setting it to VCR mode.
2 PRECODED VCR buttons
These buttons transmit the chosen precoded VCR codes.
3 EXCLUSIVE TV buttons
These buttons are for operating the TV.
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes and Digital Satellite Systems. You must first
program the remote to match the remote system in your cable box. (Refer to page 22.)
click for image of remote control
1. Turn ON your cable box.
2. Aim the remote control at the front of your cable box.
3. While holding down the CABLE button on the remote, enter the 2 digit preset code that matches your cable box
as shown on page 22. The remote will turn off your cable box when the correct 2 digit preset code is entered.
When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after 5
seconds, try a different 2 digit preset code.
4. The remote will now control your cable box.
NOTES:
1. If your cable box cannot be operated after performing the above procedures, this means that your cable box
codes have not been precoded into the remote.
2. In the unlikely event that your cable box cannot be operated after performing the above procedures, please
consult your cable box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your cable box does not have a power function, the remote will issue the CHANNEL UP function.
1 CABLE button
This button allows the remote to control your cable box by setting it to CABLE mode.
2 TV/VCR buttons
When the remote is in CABLE mode, this is the A/B button.
3 ENTER buttons
If your cable box does not have an enter function, this button will send the TV enter code.
4 RECALL button
If your cable box button does not have a last channel function, this button will send the TV channel recall code.
5 PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded CATV codes.
6 EXCLUSIVE TV buttons
These buttons are for operating the TV.