Filter
Top Products
HOW TO USE THE REMOTE TO CONTROL YOUR TV - 15 -
All the On-Screen Display features can be set or adjusted by using these buttons.
The "MENU" button will start the On-Screen Display.
The "CURSOR" buttons will highlight functions or adjust and set different features.
The "ENTER" button will set features to your preference.
4 CHANNEL SELECTOR buttons
"CHANNEL SELECTOR" buttons are used to set the time, for channel memory, etc..
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9. For channels 100 and above,
press the 1 button, wait until another dash appears next to the channel display on your TV, then enter the
remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (
) or down ( ).
NOTE: The TV may not receive some channels if you are not in the correct AIR/CABLE mode. (See page 24.)
5 AVX button
The AVX (Auxiliary Video) button will select between the antenna signals and the video input jacks each time the
button is pressed. If the Picture-in-Picture is on, the AVX button will select between the video input jacks only.
(See page 10)
FOLIOHG2
<IMG SRC="ObjFE4.PCX">
6 VOLUME, MUTE buttons
Press the "VOLUME" up (
) or down ( ) button until you obtain the desired sound level.
To turn the sound off instantly to answer the telephone, etc., press the "MUTE" button. Press the "MUTE" button
again or press the "VOLUME" up (
) button to restore the sound.
Closed Caption will be displayed when the "MUTE" button is pressed.
7 LAST CHANNEL (LST-CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)