USING THE GENIUS REMOTE TO CONTROL CABLE BOX FUNCTIONS
22
USING THE GENIUS REMOTE TO CONTROL CABLE BOX FUNCTIONS
• To operate your cable box, point the Genius remote at the remote sensor
of the cable box.
The Genius remote is designed to operate different types of cable boxes.
You must first program the Genius remote to match the remote system of
your cable box. (Refer to Table 2 on page 18).
(1) Turn ON your cable box.
(2) Set the Multi-Page select switch on the Genius remote to
MENU/CATV.
(3) AIM the Genius remote at the front of your cable box.
(4) While holding down the SELECT button, press the button that matches
your cable box as shown on page 18. The channels on the cable box will
begin changing after 5 seconds when the correct button is pressed. When
this happens the Genius Remote control is programmed for your cable
box. If the cable box channels do not change after 5 seconds, try a
different Genius Remote button.
(5) Release both buttons when the cable box starts to change channels.
The precoded cable box buttons will now control your cable box.
NOTES:
• If your cable box cannot be operated after performing the above procedures,
the codes have not been precoded into the Genius remote control and it will
not be able to operate your cable box.
• You will only have to program your remote control to match your cable box
once. The remote will remember the codes until you replace the batteries.
• Whenever you install or replace batteries in the Genius remote, you must
reprogram the Genius remote to match the remote system of your cable box.
• When operating your TV or VCR, remember to set the Multi-Page select
switch to the proper position.
• Be sure to keep the original remote control for the cable box even if you use
the Hitachi Genius remote to control the cable box.
TABLE 1. VCR Precoded remote controls
Press SELECT and this
VCR Brand button
Canon 6
Citizen 0
Curtis Mathis 2 / 6
Dimensia 2
GE 2 / 6
Goldstar 0
Hitachi 1
Instant Replay 6
JC Penny 1 / 6 / 9
JVC 0
Kenwood 0
Magnavox 4 / 6
Marantz 9
Marta 0