Filter
Top Products
HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV - 18 -
You can also use the RECALL button to quickly clear many of the other on-screen
displays.
3 PIP CH button
Use the PIP CH button to select between main picture and sub-picture tuning. An arrow
next to the channel number will indicate which channel is being controlled.
4 MENU, CURSOR buttons
All the On-Screen Display features can be set or adjusted by using these buttons.
The "MENU" button will start the On-Screen Display.
The "CURSOR" buttons will highlight functions or adjust and set different features.
5 CHANNEL SELECTOR buttons
"CHANNEL SELECTOR" buttons are used to set Family Favorites, Channel Memory,
etc..
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9. For
channels 100 and above, press the 1 button, wait until another dash appears next to the
channel display on your TV, then enter the remaining two numbers using the number
buttons.
Channel selection may also be performed by pressing CH up ( ) or down ( ).
You may also use these buttons for QUICK LIST. Press and hold the CH up ( ) or
down ( ) button and a window will appear allowing you to choose the channel you
wish to tune. Release the CH up ( ) or down ( ) button when the channel you wish to
tune is highlighted, and the TV will tune to that channel.
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL
SOURCE mode. (See page 29.)
6 INPUT button
The INPUT button will select between both antenna signals and the two sets of video
input jacks each time the button is pressed. If the Picture-in-Picture is on, the INPUT
button will select between the two sets of video input jacks and both antenna sources
when main channel is chosen with the PIP CH button. If the sub-picture is chosen, the
INPUT button will select between the two sets of video input jacks and the ANT A
antenna source (ANT B source cannot be displayed as a PIP Sub-Picture.)
NOTE: When ANT A is selected, the channel number in the upper right corner of the
screen is in green. When ANT B is selected, the channel number is in yellow.