Filter
Top Products
USING THE GENIUS REMOTE TO CONTROL CABLE / SATELLITE BOX FUNCTIONS
- 24 -
remote to match the remote system of your VCR. (Refer to page 24.)
Genius remote CLU-417UI Illustration
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. While holding down the VCR button on the remote, enter the 2 digit preset code that
matches your VCR as shown on page 24. The remote will turn off your VCR when the
correct 2 digit preset code is entered. When this occurs, the remote control is
programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different 2
digit preset code.
4. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that
your VCR code has not been precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above
procedures, please consult your VCR operating guide.
3. The remote control will remember the codes you have programmed in until the batteries
are removed from the remote control. After replacing the batteries repeat the entire
programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP
function.
5. The MENU button will act as the VCR MENU button for HITACHI VCR's.
6. The EXIT button will act as your VCR ENTER button if required.
7. The INPUT button will act as your VCR +100 button if required.
1 VCR Button
This allows the remote to control your VCR by setting it to VCR mode.
2 PRECODED VCR buttons
These buttons transmit the chosen precoded VCR codes.
3 EXCLUSIVE TV buttons
These buttons are for operating the TV.
USING THE GENIUS REMOTE TO CONTROL CABLE / SATELLITE BOX FUNCTIONS
Operating the pre-coded function for your cable/satellite box.
This remote is designed to operate different types of cable boxes and Digital Satellite
Systems. You must first program the remote to match the remote system of your
cable/satellite box. (Refer to page 24.)
Genius remote control CLU-417UI Illustration
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. While holding down the CABLE button on the remote, enter the 2 digit preset code
that matches your cable/satellite box as shown on page 24. The remote will turn off your
cable/satellite box when the correct 2 digit preset code is entered. When this occurs, the
remote control is programmed for your cable/satellite box. If the cable/satellite box does