Filter
Top Products
SETUP
Manual Convergence Adjustment Mode
NOTES: 1, Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.
Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence
crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the
Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the
adjustment point is WHITE, it will change to RED,
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN
(reference color). Properly aligned, all three colors should appear white.
A_pe_t I
(:hart Manag_= ¸ I
Lock'_ I
_w _ SeE I
T_OMB THUrCB
STICK STICK
Se_Lq>
f, Hgrl_ _f_ _e(_, G_,eem and _Eue
THUrCB
STICK
©.
THUM_ T_4'_MB
8T_OK STICK
I _er_LJ _,r_,f_r_nce
Adjustment Point
/Cursor
/
/
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
i 117 _anua_ Ac_iust
P_ease Enter Numbt._
0 Cancel and go to Normal _ode
1 Done and go to Nor_a_ _1ode
_ 2 [_ack to _ode
Adjust
3 Factory _tc%ot and
Back to Adju=,l= _ode
0 3 Select
Press the [0] button on the remote control to CANCEL adjusted data and return to main picture.
Press the [1] button on the remote control to SAVE adjusted data and return to main picture,
Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [3] button on the remote control to recall the factory pre-set convergence data.
Press the [9] button on the remote control to read the SAVED adjusted data. Ifthere is no saved data, pressing the [9] button will recall
the factory pre_set data.
64