Hitachi C50-FD7000 Projection Television User Manual


 
28
ON-SCREEN DISPLAY MENUǏSETUP MENUǐ
ǏAuto Linkǐ
Use this function to automatically switch on the TV and switch it to AV1 or AV5 mode when it detects a video
signal from INPUT1 or INPUT5 terminal of the TV. It provides you ease when using with your external
equipment.
Connect external equipment to INPUT1 or INPUT5 terminal of the TV. Refer to CONNECTION WITH OTHER
EQUIPMENT on page 50, 51 for more information.
Follow the steps on page 21 to enter the Setup menu and select the Auto Link option. Enter the Auto Link menu
as shown below. Press the Ÿź cursor buttons to select AV1 or AV5. Then press the ŻŹ cursor buttons to set
AV1 or AV5 to On, Auto Link function for the respective inputs will be activated.
(1)To switch on the power connected the signal source of AV1 or AV5 while the set is on. When there is an output
from the signal source, the set will switch to AV1 or AV5
from the RF or other AV receiving mode automatically.
(2)If the set is in standby mode, turn on the power
connected the signal source of AV1 or AV5, when there is
an output from the signal source, the set will turn on and
switch to AV1 or AV5 automatically. The set will turn to
standby mode automatically from the time when there is
no operation on the set for a long time.
Note˖
˄1˅If the performance of your external equipment
connected to AV1 and AV5 on the TV is not reliable, it is recommended to turn off the Auto Link
function to avoid the misoperation.
˄2˅If you use your external equipment or the videocassette recorder to perform recording after they are set to
On Timer, do not activate Auto Link function to avoid the misoperation.
ǏAV NETǐRefer to page 35-45.
$XWR/LQN
$9
 2Q
$9
2Q


6HOHFW
5HWXUQ
6HW
ź
Ź