Hitachi L42VK04U Flat Panel Television User Manual


 
English - 10 -
Subwoofer Out5. is for connecting an external, active subwoofer to the set to give a much deeper bass
effect. Use an appropriate RCA cable to connect the TV set to a subwoofer unit.
S/PDIF Coaxial Out6. outputs digital audio signals of the currently watched source.
Use an SPDIF coaxial cable to trasfer audio signals to a device that has S/PDIF input
RF Input7. connects to an aerial antenna system.
Note that if you use a decoder or a media recorder, you should connect the aerial cable through the device
to the television with an appropriate antenna cable, as shown in the illustration in the following pages.
PC Input8. is for connecting a personal computer to the TV set.
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC
HDMI Inputs9. are for connecting a device that has an HDMI socket. Your LCD TV is capable of displaying
High De nition pictures from devices such as a High De nition Satellite Receiver or Blu-ray Player. These
devices must be connected via the HDMI sockets or Component Socket. These sockets can accept either
720p or 1080p signals. No sound connection is needed for an HDMI to HDMI connection.
Viewing the Connections - Side Connectors
CI Slot is used for inserting a CI card. A CI card allows you to view all the channels that you subscribe 1.
to. For more information, see “Conditional Access” section.
Side USBs2.
Headphone jack is used for connecting an external headphone to the 3.
system. Connect to the HEADPHONE jack to listen to the TV from
headphones (optional).
Video Input is used for connecting video signals of external 4.
devices. Connect the video cable between the VIDEO IN socket
on the TV and the VIDEO OUT jack on your device.
Audio Inputs are used for connecting audio signals of external 5.
devices. Connect the audio cable between the AUDIO
INPUTS on the TV and the AUDIO OUTPUT jacks on your device.
NOTE: If you connect a device to the TV via the VIDEO INPUT, you should
also connect your device with an audio cable to the AUDIO INPUTS of the TV to
enable audio.
The Power-switch is used for turning the TV “Off” or into “Standby-Mode”6.
Power Connection
IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.
Aerial Connection
Connect the aerial or cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
5Vdc-Max500mA
[GB]_MB65_3900UK_IDTV_42843W_BRONZE18_10073078_50189657.indd 10[GB]_MB65_3900UK_IDTV_42843W_BRONZE18_10073078_50189657.indd 10 31.05.2011 14:51:0031.05.2011 14:51:00