Filter
Top Products
English - 13 -
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of •
the handset by gently pulling backwards from the
indicated part.
Insert two • AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
+
+
-
-
NOTE: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, •
50 Hz outlet.
Switch the “•
” button to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch on the TV from standby mode either:•
Press the “•
” button, P+ / P- or a numeric button
on the remote control.
Press the “• ”, - or + button of the TV.
The TV will then switch on.
NOTE: If you switch on your TV via P +/- buttons
on the remote control or +/- on the TV set, the
programme that you were watching last will be
reselected.
By either method the TV will switch on.
To Switch the TV Off
Switch the“• ” button to position 2 as illustrated,
(
) so the TV will switch OFF.
To power down the TV completely, unplug •
the power cord from the mains socket.
NOTE: When the TV is switched to standby
mode, standby LED can blink to indicate that
features such as Standby Search, Over Air
Download or Timer is active.
Digital Teletext (** for UK only)
Press the “• ” button.
The digital teletext information appears.•
Operate it with the coloured buttons, cursor buttons •
and OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on digital teletext
screen.
When Press “• SELECT” button or similar message
appears on the screen, press the OK button.
When the “•
” button is pressed, the TV returns to
television broadcasting.
With digital terrestrial broadcasting (DVB-T), in •
addition to digital teletext broadcasting together with
the normal broadcasting, there are also channels
with just digital teletext broadcasting.
The aspect ratio (picture shape) when watching •
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.
When you press the “•
” button again, the digital
teletext screen will be displayed.
Analogue Teletext
Please do refer to the “TELETEXT” explanation on
page 29.
Input Selection
Once you have connected external systems to
your TV, you can switch to different input sources.
Press “SOURCE” button on your remote control
consecutively for directly changing sources.
You can operate your TV using both the remote control
and onset buttons.
[GB]_MB65_3900UK_IDTV_42843W_BRONZE18_10073078_50189657.indd 13[GB]_MB65_3900UK_IDTV_42843W_BRONZE18_10073078_50189657.indd 13 31.05.2011 14:51:1231.05.2011 14:51:12