Filter
Top Products
79
On-Screen Display
After the CableCARD has been successfully installed,
you can access CableCARD Information menu in the
SETUP menu of the On-Screen Display.
1. Press the MENU button on the Remote Control to
access the Main Menu screen.
Follow the instructions below to access the CableCARD
Information menu.
2. Use the CURSOR PAD
̄ to highlight SETUP in
the
Main Menu and press the SELECT button.
3. Use the CURSOR PAD
̄ to highlight CableCARD
Information and press the SELECT button.
4. To view the CableCARD ID and Host ID, use the
CURSOR PAD
̄ to highlight CableCARD Info and
press the SELECT button.
Move SEL Return
Select the button below to acess
CableCARD ID and Host ID.
Select the button below to access
CableCARD and Host Diagnostics.
CableCARD Info.
Diagnostics Info.
In order to start cable service
for this device, please contact
your cable provider
CableCARD(tm): 123-456-789-1
Host: 123-456-789-1
Data: 123-456-789-1
Unit Address: 123-456-789-1
Press EXIT to return
NOTE: The Diagnostics
Info. window is for
Service use only.
THINGS TO CHECK WHEN USING THE
CableCARD / CableCARD Services
1. Check that the CableCARD is properly inserted in
the CableCARD slot.
2. Remove the CableCARD by pulling
the CableCARD straight out.
3. Visually inspect the CableCARD to ensure all pin-
holes are in good condition, with none blocked or
damaged.
4. Make sure the CableCARD is re-inserted in the
correct direction, then slowly push until it is fully
seated in the slot.
5. When the CableCARD is installed, note all screen
messages that appear (“CableCARD Installed”,
“Acquiring Data”, “CableCARD is not Installed”).
If the “CableCARD Installed” message does not
appear when card is installed, check the TV’s card
slot and CableCARD pins for obstructions or
damage.
6. If problems still remain, please contact your Cable
Service Provider.
NOTES:
1. When a CableCARD is installed, Auto
Channel scan will not be needed
because the channel list is automatically
loaded to the TV's channel memory.
2. The TV will take several minutes to
detect and recognize the presence of the
CableCARD. This process must be
completed before any CableCARD
information or Channel listings is
accessed.
Setup
TV Guide On Screen
Move SEL Select
Setup
Timers
Channel Manager
Locks
Audio
Video
Power Swivel
Move SEL Select
Set The IR Out
Set The Closed Captions
Set The AV Net
Set The Inputs
Set The Screen Saver
Setup The Menu Options
Setup
OR
CableCARD Information
Select The Quick Start Option
Reset The Software
CableCARD Information
Setup
OR