Filter
Top Products
30
ENGLISH
SETUP OPERATION (continued)
How to Use the Learning Option of the Remote Control
Learning Setup on the Hitachi Remote Control
This optional feature allows the user to capture (Learn)
remote control codes from other device’s remote control.
The Hitachi remote control can be used to control other
devices. To learn a code from your device follow the next
steps.
On your Hitachi R/C select the desired device mode 1.
(TV, DVD, PVR/VCR, SAT/CBL or AVR) by using
the mode button, to position the LED indicator in
which the IR codes (Keys) will be captured.
Press and hold down the Mode key that you selected 2.
on the remote and enter the digits “9”, “7”, “5” in
sequence.
The Mode LED will come ON indicating that is ready 3.
for learning and will remain ON until the process is
complete.
On the Hitachi R/C press a key that will learn the 4.
new code from the other device R/C.
The mode LED will blink rapidly and keep blinking 5.
for 5 seconds and the LED will turn off and await a
different key press.
Point the teaching R/C directly to the IR LED on the 6.
Hitachi R/C and press the key that contains the IR
code to be sent or captured.
If the code is learned successfully, the mode LED 7.
will blink twice and turn off. The remote will stay in
learn mode (return to step 4). If the code is not learn
successfully, the respective mode LED will blink for
1 second and you will have to return to step 4.
In order to exit the learning process, press and hold 8.
the Mode key for 3 seconds.
LEARNING SETUP EXAMPLE (Learn AUDIO (language)
key from a DVD player)
Press and hold DVD mode on the R/C.
Enter the sequence “9,7,5” keys of the Hitachi R/C.
Press the LAST CH key of the Hitachi R/C.
Point your DVD player R/C in front of the Hitachi R/C
receiver and then push the AUDIO key from the device
R/C.
The Mode LED will blink twice meaning that was
successful. If not repeat from step 3.
Press and hold DVD mode on the R/C to nish.
Press the Mode key selected on the R/C.•
Press and hold the Mode key and enter the •
following sequence “9,7,6”.
Press the key where the learning IR code was •
stored.
Press again the key where the learning IR code •
was stored.
If the code is deleted successfully, the Mode LED •
will blink twice and turn off.
NOTE
At step 6 a one second LED blink means a learning
failure, which could mean: a) Bad capture, try
again, b) Memory full (delete some function), or c)
Unlearnable code.
At step 4 a one second LED blink means low
battery or faulty flash memory detected (The R/C
can not perform learning mode if either of these
conditions exists).
How to Delete Learning